Home Page
Products
Model 110
Model
100S
Model 1000 "YOUR ANSWER TO TUBE BENDER REFORM"
|
Home Page
Products |
|
Model 110
Model
100S
Model 1000 |
|
The Model 100 "YSE" (pronounced "wise") Controller is a single axis controller for pipe and tube bending machines with four cylinders. It is designed specifically to enhance your present machine and add capability similar to new programmable machines at a fraction of the cost. Microcomputer -based, solid state design, and user-friendly controls combine for a highly featured controller with long term reliability.
Installing and Operating a "YSE"
The Model 100 "YSE" Controller is part of a kit which includes a high resolution optical encoder, wiring harness/cable assembly, and detailed installation instructions. A complete step-by-step operator's manual includes numerous examples to help reduce learning time.
 | Patent pending "automatic bend angle compensation" for more accurate bends | ||||||||||
| Angular resolution of 0.1 degrees | ||||||||||
| Programmable from 0.1 to 360 degrees | ||||||||||
| Program up to 99 jobs with up to 10 bends per job | ||||||||||
| Battery backed internal memory; programmed jobs remain when power turned-off | ||||||||||
| Manual, setup and automatic cycle operation | ||||||||||
| Sequential control of bend arm, mandrel, clamp and pressure die assist or deceleration | ||||||||||
| Individual control of bend arm, mandrel, clamp and pressure die assist or deceleration | ||||||||||
| Mandrel and bend arm oscillation feature with programmable angle and time | ||||||||||
| Parts counter settable for up or down counting | ||||||||||
| Job view function to view all bends with a programmed job | ||||||||||
| Over bend fixed angle compensation | ||||||||||
| Sequence operation (can lock out mandrel or pressure die assist if not in use) | ||||||||||
| Jog feature with programmable jog angle | ||||||||||
| Machine switch state automatically set at controller; no rewiring required | ||||||||||
| Operation as a 180 or 360 degree machine | ||||||||||
| Machine configuration lock out feature to prevent unauthorized changes | ||||||||||
| Programmable bend arm starting delay | ||||||||||
| Deceleration angle programmability | ||||||||||
| Two button sequence operation, forward and reverse | ||||||||||
| Operator user friendly | ||||||||||
| Controller part of complete retrofit kit
including:
| ||||||||||
| Controller kit geared for customer installation | ||||||||||
| Complete installation and operator's manual | ||||||||||
| Optional pedestals available | ||||||||||
| Offered in 110/220 VAC operation | ||||||||||
| A clean retrofit to your existing tube or pipe bending machinery | ||||||||||
| Clockwise or counter-clockwise machine configuration | ||||||||||
| Highly visible LED numeric display | ||||||||||
| Industrial grade touch panel and display with 15 function keys | ||||||||||
| Heavy duty industrial enclosure with simple disconnect | ||||||||||
| Emergency Stop safety feature | ||||||||||
| Bend arm speeds up to 50 RPM | ||||||||||
| Over-bend capability for springback allowance that are automatically added to each programmed bend of a job |
Complete retrofit kit is priced at $6500
The controller will increase the efficiency, productivity with lower setup times (from a typical 30 minutes to less than 5 minutes), and profitability (through the reduction of material scrap) of your industrial pipe and tube bending machinery. The controller is designed to enhance your preset single axis, four cylinder, industrial tube or pipe bending machine by adding this fully featured automation system. With an improved USER-FRIENDLY control system it is an extremely cost effective alternative to buying new equipment.
The Model 100 "YSE" Controller comes with a full one year warranty covering all parts and labor. Complete factory service and technical support are available at (800) 392-1313. Fortuna Products Inc. will satisfy all your needs and questions, and above all - minimize your down-time.
Back to Top | Home Page | Products | Model 110 | Model 100S | Model 1000
